VESDA ECO provides early warning of toxic, oxygen and flammable gas hazards to protect personnel and property whilst ensuring business continuity. In many facilities, unseen dangers exist from gases and other hazardous substances that can cause enormous damage and loss of life. VESDA ECO was developed to provide cost-effective gas detection and environmental monitoring in numerous application and environments.
– Battery charging rooms
– Boiler plant rooms
– Commercial kitchens
– Parking garages
– Utility / Service tunnels
– Refrigerated stores and plant rooms
– Water treatment and sewerage plants
– Power generation plants
– Metal processing plants and more
How It Works
VESDA ECO uses an existing or new aspirating pipe network to actively monitor for gas escapes and build-ups. Each ECO gas detector can house up to two gas sensors, and additional detectors can be added easily to the pipe network to monitor more gases if required. Pre-calibrated sensor cartridges are easily replaced in the field and make converting to different gas sensors or replacing sensors a simple task.
The VESDA ECO detector is configured using Xtralis VSC configuration software and can be remotely monitored using Xtralis VSM4 monitoring software. Both VSC and VSM can be used to download data from the onboard memory card for data analysis and trending of historical data.
VESDA ECO by Xtralis provides significant installation and routine maintenance cost savings over conventional multi-point gas detection solutions, by reducing the number of detectors required to cover an area and by providing easy access for routine maintenance.
As air from a given area is drawn to the VESDA ECO detector, it can be conditioned to remove moisture, dirt, particulates and other contaminates. This continuous, active air sampling, enabled using a VESDA ASD and pipe network with multiple sampling holes, dramatically increases the ability to detect a gas release quickly and in a wider range of environments, even in areas with high air flows.
– Toxic, Oxygen or Flammable gas detection
– Single or dual gas versions
– Factory calibrated sensor cartridges
– Integral alarm status LEDs
– Integrates with PLCs/HVAC/BMS/FACP
– Configurable relays
– 4-20 mA analog outputs
– RS485 Modbus output
– On-board event logging
– On-board fault diagnostics
– Integral gas test port
– Remote reset
Supply Voltage: 18 – 30VDC
Power Consumption: 3.6W (max)
Current Consumption: Typically 60mA @ 24VDC for dual gas (flammable / toxic) Quiescent. 85mA when in alarm.
Dimensions (WHD): 34mm x 125mm x 110mm